Pioneerpos AT Commands G24-LC Uživatelský manuál stáhnout pdf (Strana 390)

100

101

Sleep Mode

4-22 G24-L AT Commands Reference Manual April 15, 2008

Sleep Mode

Note: The notation of TXD and RXD are from the perspective of the terminal unless otherwise

specified.

The terminal should activate Sleep mode by sending ATS24=n (n - number of seconds). To

disable Sleep mode, send ATS24=0.

Example of G24-L Entering Sleep Mode

Terminal-TX: ATS24=n

Terminal-TX: ATxxx

Terminal-Wakeup-In=Inactive//n seconds passed since last command (and other conditions met)

G24-L-CTS=Inactive//G24-L enters Sleep mode

Example of Terminal Wake G24-L Sleep Mode

Terminal-Wakeup-In=Active

G24-L-CTS=Active//G24-L exits Sleep mode

Terminal-TX: ATxxx//30 mseconds passed since Terminal-Wakeup-In became active

Example of G24-L Wake Terminal Up

G24-L-CTS=Active//G24-L internal event occurred. Incoming call is pending

//G24-L exits Sleep mode

G24-L-Wakeup-Out=Active

G24-L-TX: RING//T mseconds passed since Terminal-Wakeup-Out became active

(T is defined by ATS102.)

The figure below shows a Sleep mode example when S24 > 0.

Figure 4-11: Sleep Mode when S24 > 0

G24-L

CTS

(When at+mscts=0

The default)

G24-L

sleep

mode

(clock)

DTE TXD

awake

sleep

S24

Less then S24

30 ms

WAKEUP_IN

30 ms

S24

1 2 ... 385 386 387 388 389 390 391 392 393 394 395 ... 443 444

Komentáře k této Příručce

Žádné komentáře

Pioneerpos AT Commands G24-LC Uživatelský manuál Strana 390

Komentáře k této Příručce